5 replies to this topic

[bloodredorion]

Sorry, I'm not even sure if I'm putting this topic in the right place or not... 

 

So I'm trying to add / replace portraits from FE7 with portraits that I have made. I tried replacing Lyn with this portrait in FEditor Adv. and it said this: 

 

 

I've ran my picture through Usenti, so I don't think it's the color limit... (Unless I did it wrong.) 

And it's transparent already.

 

So what's going on?

 

Here's the picture:

 

 

Any ideas/help will be greatly appreciated, thank you.

[^Leo^]

i think you may have it the wrong size. not sure if that's actually the problem or not, but that would most likely make FEditor ADV throw an error.

[bloodredorion]

So I found this image thing, which you're apparently supposed to use to get the proportions right... 

I can't seem to get my transparent image onto these blocks without making them non-transparent again. 

 

Does Usenti let you put transparent images on these blocks? If there is an option to, I can't find it.

[bloodredorion]

UHM... WHAT HAPPENED? HELP?

Attached Files

•  ooooooooooooooooooooooooooooooo.png   32.83KB   0 downloads

[Elwood]

Sometimes it doesn't put the mouth and eye frames in the right place. Just click and drag them into position.

[^Leo^]

if they don't line up properly just shift the big portrait around in the bitmap that you're trying to inject. a lot of times mine were a few pixels off of where they should have been making the eye/mouth frames not line up properly.